wall is a specific proportion 

produce damage, and the furniture of the force nodes are often at the end of the material, so the need for its end special treatment to increase the strength, Cost and technical difficulty; In addition, consumers in the appreciation of the details of the requirements of the furniture, requiring the end of the treatment not only consider the force, but also must consider the form of beauty and change, the use of clean and comfortable requirements, The use of materials in the field of furniture difficult.?(3) limited connection?At present, the

commonly used way of wood-plastic materials is through the mouth of the card, nail, bonding. The mouth of the mouth can be very good restrictions between the two dimensions of the activities of the structure, reliable structure, but the use is limited to the surface of the flat, difficult to use as a support structure; staples require sufficient depth of the hinge, generally need in the hollow profile The internal filling of wood, the production efficiency is low; bonding on the contact surface has a higher demand, production is difficult to achieve

automation, glue may flow to the surface affect the appearance.?1.2 Surface quality?(1) flatness is an important factor in the quality of furniture, whether solid wood furniture or plate furniture are demanding on this, the wood-plastic materials, this request is particularly harsh. After the extrusion of the wood-plastic material from the hole, the local deformation is caused by the internal stress. Although the change of the environmental humidity has little effect on the wood-plastic material, the large temperature difference leads to the warping

exterior available sawing composite floor



mid century modern wood squares paneling



wpc decking villa wooden house