chenchen12495
Posts: 839
Joined: 8/9/2016
|
also prevent the floor dry |
Flag »
Reply »
|
and then wax, so wax layer can not be completely attached, leaving the floor a little bit of white spots. The only way to completely solve the problem of how to drag the wood floor was bright!What kind of geothermal floor thickness of the best? In order to increase the thermal conductivity, cushion material and floor thickness should not be too thick. Consumers are advised to carefully select the same time, try to use small size, so that uniform heat distortion. The thickness shall not exceed 15 mm. It is understood that the
principle is to warm the low-temperature radiation through the heat transfer, the wood itself is a bad conductor. Therefore, this requires geothermal floor can not be too thick. When the thickness of more than 15 mm, the radiation heat is difficult to reach the surface of the floor, low energy efficiency, heating effect will be unsatisfactory. As a geothermal floor, it is best not to choose too long or too long floor, the larger the size of the floor, the gap generated in the geothermal environment is also greater. In particular, the width of the single-
layer three-layer parquet, if the moisture content of the surface layer should be controlled below 8%, otherwise there will be floor surface cracking. In geothermal conditions will also produce cracking. Therefore, as a geothermal three-layer parquet in the production, we must strictly control the moisture content of the surface layer. Strengthen the difference between the floor price difference How to distinguish its quality is good or badWith the improvement of living standards, strengthen the floor as the market in recent years, more
wood plastic usage in the world
Eco friendly Exterior Wood Wall Panels
plastic marine panels
|
|
|
Tuesday, January 10, 2017 at 9:51:30 PM |